|
Dear RTCU User,
This newsletter is to inform you about firmware release 4.77 for the
RTCU A9i, RTCU M10 Series and the RTCU M11/M11i Series.
Read about the enhancements below.
Best regards,
The Logic IO Team
Firmware 4.77 for A9i, M10 Series and M11/M11i Series.
Firmware version 4.77 for the RTCU A9i,
RTCU M10 Series and the RTCU M11/M11i Series has been released today with
the following enhancements:
-
M11/M11i GPS:
Automatic recovery of a problem in the Trimble Lassen SQ/IQ GPS firmware resulting
in lack of a fix after long time without GPS-signal. This firmware
release automatically recovers from this situation after maximum 7
minutes.
-
M11/M11i GPS:
Reduced start-up time for GPS. First fix after boot now arrives
approx. 50% faster.
-
GPS behaviour changed
so that last known course over ground (COG) is returned when speed
(SOG) is 0.
-
M11/M11i Battery
support enhancement:
Low battery now with hysteresis of approx. 5 seconds to avoid
spurious low battery conditions.
-
M11/M11i Battery
support enhancement:
batIsCharging() returning true below 0 degrees Celsius when not
charging has been fixed.
-
Problem with mxWait()
that occasionally could reset the unit has been fixed.
-
serGetCTS() /
serSetRTS() did not work in 4.76. It has now been fixed.
-
Application profile
information is now cleared after a successful application background upgrade.
Upgrade to this release is only recommended in the cases where some of
the listed
enhancements has been requested or are necessary by the actual
application.
Please
download it from www.rtcu.dk
...under development
Logic IO are always busy working on new enhancements and
products.
Currently we are working on the following:
-
RTCU MX2
The "next generation" RTCU that will be a more compact design with a
powerful 32-bit processor, extremely advanced power-management,
CAN-bus, SD-CARD support, Bluetooth and Camera support. -
Encrypted and Compressed GPRS Gateway communication.
Higher safety and lower communication costs are the result of these
coming features! -
more...
Suggestions, comments and ideas to new features/products are always
welcomed...
|